info@saswell.com
English 
français
Deutsch
русский
español
العربية
简体中文
Remember, this is for electric water heaters:
1.Safety first, cut the power off at the breaker.
2.Remove the access panel(s) and insulation so you can access the thermostat(s). You may have one or two access panels. Most water heaters have two elements/thermostats.
3.Use the voltage meter to make sure the power is completely off.
4.Take a picture of the wiring within each panel so you can reference it later when you're putting everything back together.
5.Remove the wiring from the thermostat.
6.You need to remove the entire bracket that holds the thermostat in place. Pry out each side one at a time using a twisting motion, but be gentle. Don't force it, or you can break it. You don't want to have to replace that part too, so take your time with this step and get it right.
7.Slide the new thermostat into the bracket, slide the bracket back into place, and replace the wiring.
8.Turn the power back on and allow time for your tank to heat up.
online service
8675528906113